Description

Control to Start and Stop Network Streaming.

typedef struct {
  u16 streamingControlMask;
} SLAStreamingControl_t;

Application should previously have configured the corresponding network display via SLASetEthernetDisplayParameters_t. Applications can start and stop streaming on both networks at the same time by enabling Streaming Control Mask 'Start' bits or 'Stop' bits for both the network displays. Streaming control is ignored if 'Start' bit and 'Stop' bit of that network is set to 1.

When an H.264 stream is started, an I-FRAME is generated.

Also sent in response to SLAGetParameters_t().

Note

KLV output depends on rates set by SLATagDataRate_t
NET1 is not available on 1500, so bit is ignored. see Network Display ID

Message ID 0x90

Byte Offset

Name

Description

4-5

streamingControlMask

Streaming control: Corresponding Start and Stop bits should not both be 1 or the entire command will be ignored

Bit	Description
0	1 = Start streaming on Net 0 (indicates streaming active in response), 0 = no effect on streaming
1	1 = Start streaming on Net 1 (indicates streaming active in response), 0 = no effect on streaming
2	1 = Start KLV stream on Net 0, 0 = no effect on KLV streaming
3	1 = Start KLV streaming on Net 1, 0 = no effect on KLV streaming
4-7	Reserved
8	1 = Stop streaming on Net 0 (indicates streaming stopped in response), 0 = no effect on streaming
9	1 = Stop streaming on Net 1 (indicates streaming stopped in response), 0 = no effect on streaming
10	1 = Stop KLV stream on Net 0, 0 = no effect on KLV streaming
11	1 = Stop KLV streaming on Net 1, 0 = no effect on KLV streaming
12-15	Reserved